I_B_Mongo
Well-Known Member
A few days ago I posted this in the DIY section, and didn't get any help. I also searched through previous threads, to no avail. Figued I'd give it another try here...
I just got a free upright freezer that I would like to turn into a fermentation chamber. I plan on using temp controller (still trying to pick which one-suggestions welcome) and wiring it for a heater too. I also plan on getting a SS conical to put in it.
My main problem is, the freezer has tubing running under the three shelves. This tubing is obviously connected to the compressor to keep the thing cold. I need to take out the shelves so I'll be able to get the conical in there. Taking the shelves out will be easy, but, I'll have to bend the tubing out of the way. I'm concerned because I know that if I kink the tubing the whole thing is shot.
Anybody have suggestions???
I just got a free upright freezer that I would like to turn into a fermentation chamber. I plan on using temp controller (still trying to pick which one-suggestions welcome) and wiring it for a heater too. I also plan on getting a SS conical to put in it.
My main problem is, the freezer has tubing running under the three shelves. This tubing is obviously connected to the compressor to keep the thing cold. I need to take out the shelves so I'll be able to get the conical in there. Taking the shelves out will be easy, but, I'll have to bend the tubing out of the way. I'm concerned because I know that if I kink the tubing the whole thing is shot.
Anybody have suggestions???