Eskimo Spy
Well-Known Member
I just finished building my MLT, thanks FlyGuy! It took three different hardware stores to find it all, but it's all done, and tighter than a gnat's ass. I ended up using hose clamps from work, the building guys use SS clamps and screws in solution, so I know the screws won't get all crappy.
Oh, and another way to get a clean cut on your braid: I cut the ends, then put in a small piece of copper tubing in the ends of the braid and used a handheld pipe cutter to cut a clean line.
Here's a question, though; how do you guys clean this after a mash? Do you actually disassemble the whole thing? Do you just remove the braid, then run hot water through it?
Pics of my beautiful new MLT:
Oh, and another way to get a clean cut on your braid: I cut the ends, then put in a small piece of copper tubing in the ends of the braid and used a handheld pipe cutter to cut a clean line.
Here's a question, though; how do you guys clean this after a mash? Do you actually disassemble the whole thing? Do you just remove the braid, then run hot water through it?
Pics of my beautiful new MLT: