I am in the planning stage of building a control panel for my temp controlled natural gas brewstand. My build is based on this post:
https://www.homebrewtalk.com/f51/gas-temperature-control-dummies-116632/
I'd like to put all of the electronics that make this system work into the control panel and then use panel mounted disconnects/plugs for all the wiring to external items (RTD's, Pumps, gas valves). I have disconnects that will work for everything except the high voltage spark wire that will run from the Honeywell intermitent pilot controls to the pilot ignitor/sensor (just like the spark plug wire on your car). Basically I want to run a wire from the pilot controls inside the enclosure to the panel mounted disconnect, then on the outside of the enclosure the spark wire would plug into the disconnect and go to the ignitor. Does anyone know of a panel mounted connector that I can use for this? Any ideas?
https://www.homebrewtalk.com/f51/gas-temperature-control-dummies-116632/
I'd like to put all of the electronics that make this system work into the control panel and then use panel mounted disconnects/plugs for all the wiring to external items (RTD's, Pumps, gas valves). I have disconnects that will work for everything except the high voltage spark wire that will run from the Honeywell intermitent pilot controls to the pilot ignitor/sensor (just like the spark plug wire on your car). Basically I want to run a wire from the pilot controls inside the enclosure to the panel mounted disconnect, then on the outside of the enclosure the spark wire would plug into the disconnect and go to the ignitor. Does anyone know of a panel mounted connector that I can use for this? Any ideas?