I know this has been overkilled, but I just hooked up two commercial kegs to my keezer (36-38 degrees) off a single regulator (set to 9psi) split by a dual manifold. The lines are 3/16" and 5 feet. The Double IPA is flowing perfect and has little to no air bubbles in the line. The Orange Wheat is collecting quite a bit of small air bubbles and gas pockets in the beer line. The shanks are run through the collar and all lines are internal. Why is the one line collecting bubbles, but the other isn't? Should I just increase the length of the one line?
Any help would be appreciated. I was just wondering why one would be running fine on the same system and the other having problems.
Thanks
Any help would be appreciated. I was just wondering why one would be running fine on the same system and the other having problems.
Thanks