lgxg
Well-Known Member
hey guys. i'm just finishing my brewstand. it'll by a hybrid, natural gas with a 120v rims to maintain mash temps.
i've got a chugger pump, with a blichman three piece valve and male camlock. i only have one pump and it's mounted directly below the mash tun. the boil kettle is on the right in the pic.
is it a stupid idea to mount the rims directly to pump, using a female camlock connection?
i was trying to think where i'd put a rims tube in this setup, and it it would have to be to the right of the pump since this is the output. it would be nice to have it totally removable so I can flush it afterward. the output would be on top with the RTD, then connected to a camlock with locline inside the mash tun.
i'm planning on using this rims tube: http://www.brewhardware.com/rimsherms-parts/122-rims
what do you all think?
i've got a chugger pump, with a blichman three piece valve and male camlock. i only have one pump and it's mounted directly below the mash tun. the boil kettle is on the right in the pic.
is it a stupid idea to mount the rims directly to pump, using a female camlock connection?
i was trying to think where i'd put a rims tube in this setup, and it it would have to be to the right of the pump since this is the output. it would be nice to have it totally removable so I can flush it afterward. the output would be on top with the RTD, then connected to a camlock with locline inside the mash tun.
i'm planning on using this rims tube: http://www.brewhardware.com/rimsherms-parts/122-rims
what do you all think?