Strongbad52
Well-Known Member
After deciding to replace my Gott cooler MLT with a inverted Sanke I was trying to figure out how to keep the falsebottom fixed without welding or buying a 15" FB from Jaybird. I stumbled onto an easy weldless option to keep the false bottom from sliding around.
I figured there was some way to use the lip on inside of the Sanke neck that the spear normally rests on and while wandering around Home Depot I found this in the electrical dept.
[/IMG]
and after tearing open and testing out what seemed like half the fittings at Home Depot, I found that a 1/4" male flare threads fit the aluminum connector. After that it was fairly simple to find a 1/4" to 1/2" bushing and a 1/2" cap to finish it off and voila!!
[/IMG]
[/IMG]
[/IMG]
[/IMG]
I figured there was some way to use the lip on inside of the Sanke neck that the spear normally rests on and while wandering around Home Depot I found this in the electrical dept.
and after tearing open and testing out what seemed like half the fittings at Home Depot, I found that a 1/4" male flare threads fit the aluminum connector. After that it was fairly simple to find a 1/4" to 1/2" bushing and a 1/2" cap to finish it off and voila!!