I recently purchased the Whirlpool WAR488BSL mini fridge for my DIY kegerator conversion.
I have a 20# co2 tank that will have to be outside the fridge so Im looking for suggestions on how to pass the gas line through the fridge.
Id like to have the option to quickly connect and disconnect my dual serve regulator so I want to have 2 Cornelius posts on the outside of the fridge.
Ive seen where a bulk head is installed through the top corners of the fridge like this https://www.homebrewtalk.com/f35/co2-tank-outside-kegerator-366211/index2.html but Im not sure I have enough room in the corners to do this. The evaporator plate fills up most of the back wall and what is open in the corners is rounded so there really isnt a flat service on the inside to tighten the nut on the bulkhead down.
Ive also seen the DIY bulkhead through floor of the hump using brass fittings.
https://www.homebrewtalk.com/f51/kegerator-conversion-danby-440bl-294606/
If I did go with the bulkheads through the corners, what parts do I need besides the bulkheads to attach the corny post to the outside and the gas line to the inside. My lines have threaded nuts on them already will these thread right onto the bulkhead?
If I went with the DIY brass bulkhead through the hump floor, is connecting corny posts an option?
I have a 20# co2 tank that will have to be outside the fridge so Im looking for suggestions on how to pass the gas line through the fridge.
Id like to have the option to quickly connect and disconnect my dual serve regulator so I want to have 2 Cornelius posts on the outside of the fridge.
Ive seen where a bulk head is installed through the top corners of the fridge like this https://www.homebrewtalk.com/f35/co2-tank-outside-kegerator-366211/index2.html but Im not sure I have enough room in the corners to do this. The evaporator plate fills up most of the back wall and what is open in the corners is rounded so there really isnt a flat service on the inside to tighten the nut on the bulkhead down.
Ive also seen the DIY bulkhead through floor of the hump using brass fittings.
https://www.homebrewtalk.com/f51/kegerator-conversion-danby-440bl-294606/
If I did go with the bulkheads through the corners, what parts do I need besides the bulkheads to attach the corny post to the outside and the gas line to the inside. My lines have threaded nuts on them already will these thread right onto the bulkhead?
If I went with the DIY brass bulkhead through the hump floor, is connecting corny posts an option?