I received a 15G aluminum pot as a gift. It is 1/4" thick aluminum and it looks like it is "spun" as the there are concentric lines wrapping around the entire pot/lid (inside and out).
I have a ball valve that I want to install on this, but haven't installed one ever before. I saw a thread where someone drilled into a "spun" stainless pot and it ripped the pot. I'm afraid of screwing this up. Any suggestions?
I have a ball valve that I want to install on this, but haven't installed one ever before. I saw a thread where someone drilled into a "spun" stainless pot and it ripped the pot. I'm afraid of screwing this up. Any suggestions?