As some of you know I am opening a taproom and small brewery here in Eagle. I am building a new system and planning on 3bbl brew days. Well my pasta maker grain mill just doesn't seem to fit into that plan.
So I bought a barebones JSP mill. I got the hardened rollers, hardened gear option, and had them throw in some 1/2 bushings to fit the pully I purchased. My plan is to have a hopper that will fit about 50# of grain. I did not do any scientific planning for this. I just went with what looked good. I think in the end it will actually hold about 75#. I should know in a day or two.
I hope to finish the project today, but here are some pics of the progress so far.
So I bought a barebones JSP mill. I got the hardened rollers, hardened gear option, and had them throw in some 1/2 bushings to fit the pully I purchased. My plan is to have a hopper that will fit about 50# of grain. I did not do any scientific planning for this. I just went with what looked good. I think in the end it will actually hold about 75#. I should know in a day or two.
I hope to finish the project today, but here are some pics of the progress so far.