KillerKellers
Well-Known Member
So I am finally getting around to posting the pictures from last weekend. Turned out pretty good, fits 6 kegs and looks good enough that the SWMBO allows it in the kitchen!
Started off with some wood and my trusty circular saw. Compound miter saw would have been better, but this did the trick.
Here is one after hacking the wood into pieces, and placing them together to see what it will look like.
After a little bit of sanding and some stain.
Out in the heat, applied a couple coats of poly.
First placement for a dry fit.
Another view, so you can see the inside.
View with the lid.
Inside after letting the liquid nails dry on the lid.
Close up look at those perfect new Perlick faucets, and bottle opener.
Started off with some wood and my trusty circular saw. Compound miter saw would have been better, but this did the trick.
Here is one after hacking the wood into pieces, and placing them together to see what it will look like.
After a little bit of sanding and some stain.
Out in the heat, applied a couple coats of poly.
First placement for a dry fit.
Another view, so you can see the inside.
View with the lid.
Inside after letting the liquid nails dry on the lid.
Close up look at those perfect new Perlick faucets, and bottle opener.