heckels
Well-Known Member
I'm getting my HERMS system up and running and programming mash process into the BCS.
I was wondering how you guys have your strike process set up. The two options that make the most sense are to:
1. Heat enough water in the HLT to transfer about half of the strike water to the mash tun when mashing in while keeping enough in the HLT to maintain mash temps.
2. Add the necessary amount to the mash tun and the HLT and heat water in the HLT and mash tun through recirculating simultaneously.
What are the pros and cons between the two? Are the other obvious options I'm missing?
I was wondering how you guys have your strike process set up. The two options that make the most sense are to:
1. Heat enough water in the HLT to transfer about half of the strike water to the mash tun when mashing in while keeping enough in the HLT to maintain mash temps.
2. Add the necessary amount to the mash tun and the HLT and heat water in the HLT and mash tun through recirculating simultaneously.
What are the pros and cons between the two? Are the other obvious options I'm missing?