TTodd
Active Member
So during my first all-grain batch I was using a new plate chiller that we just bought. The plate chiller has barb fittings for half inch ID tubing. We were using half-inch Inside Diameter silicone tubing (that we purchased from morebeer.com).
When we attached the hose to the barb fittings on the chiller, they were not fitting very snug. So once we opened the valve on the brew pot, it started leaking from the fitting. During the entire cooling process we had to have one person firmly pushing the hoses up against the plate chiller so that it would not leak.
Has anyone else had such a problem with connecting the tubing to the plate chiller barb fittings? I suppose that I'm going to have to get some small hose clamps and attach the tubing with the clamps to ensure that it doesn't leak.
The other issue was that I just could not get it to chill properly. I had a lot of problems regulating the wort flow rate. I was just using gravity. I know that when I took a class at my local homebrew shop - they actually used a pump to push the wort through. They used a plate chiller as well and were able to dial in the rate and get a good consistent target temperature out of the chiller. Has anyone else noticed better results in using a pump instead of just relying on gravity?
Is there any references to what the flow rate of the garden hose water and flow rate of the wort?
Appreciate any input
When we attached the hose to the barb fittings on the chiller, they were not fitting very snug. So once we opened the valve on the brew pot, it started leaking from the fitting. During the entire cooling process we had to have one person firmly pushing the hoses up against the plate chiller so that it would not leak.
Has anyone else had such a problem with connecting the tubing to the plate chiller barb fittings? I suppose that I'm going to have to get some small hose clamps and attach the tubing with the clamps to ensure that it doesn't leak.
The other issue was that I just could not get it to chill properly. I had a lot of problems regulating the wort flow rate. I was just using gravity. I know that when I took a class at my local homebrew shop - they actually used a pump to push the wort through. They used a plate chiller as well and were able to dial in the rate and get a good consistent target temperature out of the chiller. Has anyone else noticed better results in using a pump instead of just relying on gravity?
Is there any references to what the flow rate of the garden hose water and flow rate of the wort?
Appreciate any input