BigPatBrewer
Well-Known Member
After finally getting a kegerator off craigslist, I have decided to spruce(or rather pine) it up with some wood. The plan is to build a new tap tower and side panels out of wood. I am using pine since I'm on a budget. For the top, I plan on using 1x4 pine for the border with a piece of penny covered plywood for the center. After it is all done I will float in some epoxy over the pennies. For the side panels, I am going to use 1x4 for the border with tongue and groove in the center. I'm still up in the air about what to do for a drip tray. The goal is to have no unfinished edges. Ill keep updating with pictures as I go.