zymurgy101
Well-Known Member
Peacedale,
What is the length between the weld on the outside of the kettle to the tri-clover barb fitting? It appears as though one could inadvertantly put quite a bit leverage on the weld or kettle wall while attaching the hose or closing the ball valve, cleaning, etc. It's probably just the angle at which the picture was taken.
Beautiful kettle though!
What is the length between the weld on the outside of the kettle to the tri-clover barb fitting? It appears as though one could inadvertantly put quite a bit leverage on the weld or kettle wall while attaching the hose or closing the ball valve, cleaning, etc. It's probably just the angle at which the picture was taken.
Beautiful kettle though!