SouthernYankee
Well-Known Member
(Update 04/17/2011) **** Photobucket isn't working right ***** I changed photo hosting to Imageshack. So some of the photos are different then originally posted from 04/07/2011. I will post more photos within a few days.
I thought I would share another Brew stand I'm building at the moment.
For those of you that have seen the thread (topic) listed below in the link. Welcome back!
First off, I know longer own the original brew stand I built last year. About 10 months ago I sold it.
I now have found that I'm in need for another stand. With this in mind. I set out to build another stand which this time around I intend to keep.
I designed this one a little different. I'm still using 1.5 inch steel tubing.
The stand itself is longer, taller. Not as wide. A little different lay out.
I'm using different casters. Not the expanding rubber insert ones. But rather the thread/nut combo ones.
Know more diamond plate, which is being replaced with expanded steel.
Only two burners are planed for this one. I knew that I would never have the need for a third burner.
I'm going to hard plum it with copper.
All the ends are welded shut. No more plastic caps..(which melted) lesson learned.
Different burner holders/windshields.
Still a lot of welding, grinding and sanding to do.....
As stated its still in the early stages. With 2 young boys. Finding time is very limited. But here are a few photos for now.
I thought I would share another Brew stand I'm building at the moment.
For those of you that have seen the thread (topic) listed below in the link. Welcome back!
First off, I know longer own the original brew stand I built last year. About 10 months ago I sold it.
I now have found that I'm in need for another stand. With this in mind. I set out to build another stand which this time around I intend to keep.
I designed this one a little different. I'm still using 1.5 inch steel tubing.
The stand itself is longer, taller. Not as wide. A little different lay out.
I'm using different casters. Not the expanding rubber insert ones. But rather the thread/nut combo ones.
Know more diamond plate, which is being replaced with expanded steel.
Only two burners are planed for this one. I knew that I would never have the need for a third burner.
I'm going to hard plum it with copper.
All the ends are welded shut. No more plastic caps..(which melted) lesson learned.
Different burner holders/windshields.
Still a lot of welding, grinding and sanding to do.....
As stated its still in the early stages. With 2 young boys. Finding time is very limited. But here are a few photos for now.