This tap goes to 7. What if you need that extra beer on tap? You can go to 7. But why not just have 6 beers on tap? This goes to 7.:rockin:
For sale is a like new 7 tap perlick tower with glycol set up and 7faucets. I have buffed all the stainless steel to remove most of the scratches. There is still a few light scratches that can really only be seen under direct light if you get it at the right angle. These scratches are hard to find once the faucets are attached. Everything has been cleaned and the tower is rust free. I have also replaced all screws and bolts and the o-rings that go on the shanks. The tower has 7 plastic clip rings that fit with the shanks into the tower. These use to be white but do to use turned off yellow. I therefore painted them black which looks very nice (even better than pure white). I have also rewrapped the faucet tubes with aluminum tape. The taps still have a very good shine but the shanks do show signs of general use. The insides of the taps also show signs of use where the acidity of the beer has taken a bit of the chrome off. The glycol tubes would be super easy to hook up some water flow with a cheap pump in a bucket with cold water and the top of the tower is filled with high density foam. All the beer tubes have barbs on the end for hooking up 3/16" line. There is one small dent at the VERY botom of the column so it isnt noticable when put together (see picture). I have tested everything at 12 psi with water and all the taps are leak free. This is ready to go. Asking $300 + shipping (actual). Feel free to ask any questions.
For sale is a like new 7 tap perlick tower with glycol set up and 7faucets. I have buffed all the stainless steel to remove most of the scratches. There is still a few light scratches that can really only be seen under direct light if you get it at the right angle. These scratches are hard to find once the faucets are attached. Everything has been cleaned and the tower is rust free. I have also replaced all screws and bolts and the o-rings that go on the shanks. The tower has 7 plastic clip rings that fit with the shanks into the tower. These use to be white but do to use turned off yellow. I therefore painted them black which looks very nice (even better than pure white). I have also rewrapped the faucet tubes with aluminum tape. The taps still have a very good shine but the shanks do show signs of general use. The insides of the taps also show signs of use where the acidity of the beer has taken a bit of the chrome off. The glycol tubes would be super easy to hook up some water flow with a cheap pump in a bucket with cold water and the top of the tower is filled with high density foam. All the beer tubes have barbs on the end for hooking up 3/16" line. There is one small dent at the VERY botom of the column so it isnt noticable when put together (see picture). I have tested everything at 12 psi with water and all the taps are leak free. This is ready to go. Asking $300 + shipping (actual). Feel free to ask any questions.