Datchew
Well-Known Member
I have 3 lids like this:
I want to have lids like this
or like this
I'm assuming these are stamped or cast 304 stainless lids. Anybody ever mod these? I can weld them easy enough, but was thinking of simply machining them out and replacing them with a swagelock pressure release that just screws in.
Any suggestions? One of these?
I want to have lids like this
or like this
I'm assuming these are stamped or cast 304 stainless lids. Anybody ever mod these? I can weld them easy enough, but was thinking of simply machining them out and replacing them with a swagelock pressure release that just screws in.
Any suggestions? One of these?