Hi all. I am starting to build a single tier brew stand with 3 burners capable of doing 10 gallon batches.
I am not set on burners yet as I am debating about doing NG versus propane. I have a NG line that terminates outside my house about 10 feet from where I need to brew which is great. However, I have no idea how big the gas line is right there. Can I tell based on the outside diameter how big it is? Also what the minimum size that would be acceptable to run 2 burners simultaneously at near full bore?
Lastly, we building a gas bar like I see everyone doing on their rigs, can I just place a gas ball valve at the inlet of each burner and turn them on/off as needed? I dont plan on any fancy automation. I just want to light them with a lighter as needed and be able to successfully run 2 burners at a time when needed. Also I assume a single regulator for either propane or NG would just be enough and I wouldnt need one for each burner right?
For burners I am leaning towards the Hurricane or Banjo burners whether I do NG or propane.
Thanks all.
I am not set on burners yet as I am debating about doing NG versus propane. I have a NG line that terminates outside my house about 10 feet from where I need to brew which is great. However, I have no idea how big the gas line is right there. Can I tell based on the outside diameter how big it is? Also what the minimum size that would be acceptable to run 2 burners simultaneously at near full bore?
Lastly, we building a gas bar like I see everyone doing on their rigs, can I just place a gas ball valve at the inlet of each burner and turn them on/off as needed? I dont plan on any fancy automation. I just want to light them with a lighter as needed and be able to successfully run 2 burners at a time when needed. Also I assume a single regulator for either propane or NG would just be enough and I wouldnt need one for each burner right?
For burners I am leaning towards the Hurricane or Banjo burners whether I do NG or propane.
Thanks all.