Search results

I run everything except my small MD 3 LG pump at 220v, if I could find a small pump for recirculating that would run at 220v I would drop 110v all together. 220v= johnson controller, HERMS 1500w Elem. duel thermometers LG MD 5 pump 110v LG MD 3 pump

you can use any 2 out of the 3ph for single phase so you could size your elements at max for 200volt 25amps, I dont have any way of finding your voltage elements over here good luck

Hello, and nice to see more Oregon Peeps

you can tap them with a wooden spoon and here a crack ring,, no crack nice even tone cracked buzzing tone

what bender did you use?

sorry for ya, but you paid way to much for that kit I sell it, same kit from Brewcraft for $140.00 and it has a 20QT 4 gall pot not 5gal

This one on LP 235,000 btus http://www.ebay.com/itm/BURNER-3-RING-ASSY-CAST-IRON-IMPERIAL-STOCK-POT-2103-/150668078233?pt=LH_DefaultDomain_0&hash=item2314846c99

I don't think its necessary, just boil it 15min before ea use and rinse it off well after use. or if your really concerned boil it before and after

most of the cheaper thermos and china made controllers use a thermister not a RTD so the response times are much slower

I own and run a auto repair shop 32years experence,, you got riped more than likely you have a bad intermitant fuel pump a weak cyl will not cause the problems you are having, a bad crank sensor would cause the truck to stall not run rough, bad cam sensor you wouldent even notice( it would...

Thanks I can do 3 of my Rasberry but your only getting 2 of my Braggot Thanks again

How many bottles do you have to send , you get four lables I don't want to give up four bottles of a 2 year old mead can we send in 2 bottles of each??? looked but didnt see anything in the rules Thanks

this is a rented tank like above says if any tank has the/a gas company name embosed on the top ring its a rented tank

No they only can use a thermistor, a real pid is your best bet like a Aurber,Love, Johnson stc.

How much??? I may be up that way next week

I just flushed my plates chillers and herms coil with nitric acid and all kinds of nasty stuff came out of both.. mold from the herms coil!! I always hot water flush/back flush and recirc PBW after brewing I now have a new cleaning secudule acid flush every 3 or 4 brews and am now using...

Lost one last kegging also, it was stuck to the floor of my ferm camber,I tried rocking, hitting it gently with my palm and cracked it along the top and down, beer leaking everywhere... did learn my chest freezer floor in the new hose slopes toward the wall and not out, now how to clean beer...

How are you grounding the element and kettle??

1/2 tri clover are 3/8 ID 3/4 are 1/2 ID and 1" are 7/8 ID I would use 1" at the min and that way you can have all the same size clamps 1 and 1 1/2 are the same clamp size. larger hose size is ok and if you get a bigger pump you'll already set up for it

not at check out "this item is no longer available sorry"