Search results

In my town we have one of the highest volume springs in Indiana. I brew with this water and thought I would get a water report. Any input would be appreciated. Had Ward's measure Zinc, too.

Looking for your thoughts on this potential grain bill for a Wit: 5.50 lb Pilsner (2 Row) Bel (2.0 SRM) Grain 48.89 % 4.00 lb Wheat, Flaked (1.6 SRM) Grain 35.56 % 1.00 lb Oats, Flaked (1.0 SRM) Grain...

CO2 DISTRIBUTORS 1/4" MFL - 3 PORT - Free Shipping This item is on eBay.

How do I connect this: with or to this: Or should I just by this:

I want to got to my local hardware (instead of buying from a home brew vendor) store for a shank washer. 1/4 inch tail piece. What size/kind am I looking for?

Primary/secondary done. Racked beer to room temp corny. While it waits for an open spot in the kegerator, should I: 1. Leave it at room temp pressurized enough to keep a good seal? 2. Leave it at room temp pressurized at 12 PSI until a space opens up? (get a little jump on carbonation)...

Assuming that a lot of brewers don't rack after the primary fermentation and just let their beer secondary in the same primary container until bottling/kegging....I have a question about cold crashing. Should I secondary as long as I feel appropriate and then cold crash or can I combine the...

Just got my 20 pound CO2 tank filled. Made note of the position of the regulator gauge that 'supposedly' tells me how full my tank is. Would taking the CO2 tank from room temp to 35-38 degrees F cause the gauge to read lower? I have been on the hunt for a leak and can't find one. But...

Yes, there were a few 'oh ****' moments.... The instructions said use a friend, so I used a wit and a chardonay 1/8 inch pilot hole ... oh no. $18 step bit (work perfect) Lubricated hole (that sounds dirty) finished hole bulkhead installed outside...

Thermoworks therampen costs around $100 and is accurate ±0.72°F from -58 to 392°F. (4 seconds to read) Thermoworks RT600 series costs around $30 and is accurate ±1.8°F from -3.8 to 247.8°F (6 seconds to read) Do I really need ±0.72°F accuracy or is ±1.8°F good enough?

Looking for an online source for colored gas side tubing.