Search results

Local Pickup Only in Roseville CA, 1) High Gravity BIAB Electric Brewing System 240V - With Plate Chiller, Pump , 24' 4 prong cable, stand and GFCI breaker - Over $1300 new - $700 2)Keg-O-Rator - 2 taps Co2 tank Holds 6- 8 Cornys - w/ modified thermostat (no external temp control needed - )...

This system here http://www.highgravitybrew.com/store/pc/BIAB-Electric-Brewing-System-240V-p3987.htm On Metal Rolar Stand, with Pump, Plate Chiller, and 30' for cord. 4prong plug $800 Located in Roseville CA

What is the best SW for Brew in a Bag?

Brewsteel Stand with 3 huge Banjo burners each with a separate needle valves for fine control, 2 pump holders with splash guards, (Stand includes heavy duty locking castors <not shown on 1 pic> ) MT, BK and HLT are all semi polished converted kegs with 4 weld-less SS ball valves (2 Valves on MT...

Thinking of going BIAB here is what I have Brewsteel Stand, Two pump holders (Includes 1 March Pump) and Castors. 3 Banjo Burners all with needle valves - Three Keggles (Mid Polish on them) All Weldless fittings from Bargain Fittings and Booby M (5 SS Ball Valves, 2 Sight Glasses with...

Anyone have a list of whats needed to build one of these?

100 bucks Local Pickup Near Sacramento California

The goal was to brew today on my new single tier.....It has been 13 months in the making and I was finally done last week. Brewsteel made the stand and I did all the kettles etc. Instead of brewing I decided to go through a brew day cycle (Glad I did I turned the wrong valve many times...

See link below http://sacramento.craigslist.org/for/3307174814.html

Thanks to Kurt at BrewSteel my stand is done!

This is for the stand only with Castors (No Pump, keggles, Burners, or Gas hardware) This is built via the wallace method using green angle iron from McMaster Carr. I have only fired it up once and I am changing my mind around design. As you can see from the video I lit up 2 burners and the...

This manifold look ok? I never did gas work before, Used pipe dope and wasn't sure how tight to go...Went as hard as I could and it leak tested fine. Will connect to 3 banjo burners. Do you think the ball valves are enough or do I need needle valves? Also whee can I get hoses with 3/8...

They want 47.67 to ship 3 burners to California. WTF doesn't that seem to high? I might as well buy them from northern brewer

How high up from the skirt should I mount my thermometer if I want to do 5 and 10g batches?

Ordering 3 bg14 what regulator should I get?

??

Figured I would share my jig creation. Looking forward to cutting this week. I took a page from BobbyM except I used the top part of the Keg Diptube (The part with the two locking tabs)as the pivot. It took a while to separate it from the tube it self (there is a lock washer holding it...

So I just purchased though I having a hard time trying to figure out my efficiency in the software. In the analysis tab should I be putting in my postboil OG reading??? Im new to AG brewing and thought it should be done on preboil Thanks