Kayos
Well-Known Member
My SWMBO got me the Millars barley mill for Christmas and I have a couple of questions:
1. How do I set the gap? I know about 1mm is good, but how can I tell? I hear you can use a feeler gauge. Just go until the knurls touch it?
2. There is a gap on one side of one of the rollers. I am thinking whole grains are going to fall through without being cracked on the side. Do I need to address it?
Here's a pic. Any info appreciated.
Not sure why it's saving the last one upside down.....you get the idea
1. How do I set the gap? I know about 1mm is good, but how can I tell? I hear you can use a feeler gauge. Just go until the knurls touch it?
2. There is a gap on one side of one of the rollers. I am thinking whole grains are going to fall through without being cracked on the side. Do I need to address it?
Here's a pic. Any info appreciated.
Not sure why it's saving the last one upside down.....you get the idea