Horseshoot
Well-Known Member
Hey all. I am in the infantile stages of my dream brew sculpture. My vision is a welded (or perhaps bolted) steel single tier. I plan on automation for shutting burners off and on, as needed. And am planing a direct fired RIMS, set-up. I am going to buy two Chugger pumps (and likely loads of other supplies!), from Bobby_M. I plan to use camlock disconnects, for ease of cleaning the lines. I am currently obtaining kegs, and converting them. The brew keggle is complete!
I have looked the site over, and have learned a lot about propane. But I still have questions.
My house uses propane only for the kitchen range. The previous owners had a propane fired clothes dryer. Ours is electric. The copper tubing for the clothes dryer propane is still in my basement (with the valve turned off!). Could I patch into this and use that source of propane? If so, what considerations do I need to make when choosing the 3 burners for my brew stand?
Thanks for any and all help!
Mike
I have looked the site over, and have learned a lot about propane. But I still have questions.
My house uses propane only for the kitchen range. The previous owners had a propane fired clothes dryer. Ours is electric. The copper tubing for the clothes dryer propane is still in my basement (with the valve turned off!). Could I patch into this and use that source of propane? If so, what considerations do I need to make when choosing the 3 burners for my brew stand?
Thanks for any and all help!
Mike