kingcat
New Member
Hello,
I followed Quaffer's keezer build (will post pics soon) and I am at the final stages. Have everything wired up according to wiring diagram and everything seems fine, but I am getting an ep2 error on the controller. Have any ideas? I have the same controller Quaffer has, the TSX 10140.
Some things I maybe don't understand: It's giving me a temp reading, but am I supposed to calibrate the thermistor in anyway? Also should the r1 parameter be set to the same value as SP?
I have the thermistor wires in the 1 and 2 inputs on the controller. They are not labelled so I'm assuming it doesn't matter which wire goes into which input.
Any help would be appreciated!!
I followed Quaffer's keezer build (will post pics soon) and I am at the final stages. Have everything wired up according to wiring diagram and everything seems fine, but I am getting an ep2 error on the controller. Have any ideas? I have the same controller Quaffer has, the TSX 10140.
Some things I maybe don't understand: It's giving me a temp reading, but am I supposed to calibrate the thermistor in anyway? Also should the r1 parameter be set to the same value as SP?
I have the thermistor wires in the 1 and 2 inputs on the controller. They are not labelled so I'm assuming it doesn't matter which wire goes into which input.
Any help would be appreciated!!