burton178
Well-Known Member
I already posted in the DIY forum, but the thread was so long that I don't know if anybody is seeing the post.
I don't mean to be impatient, but I'm going to stop by Lowe's on the way home...
Here is my post from the other thread:
I've read about how to make the round MLT with the Rubbermaid drink cooler. I have a rectangle cooler (I'm not sure but I think it's about 10 gallons. I'd say it's "medium" sized from what I've seen with a lot of coolers).
My question is... Can I still do the 12" stainless steel braid or does it have to be bigger?
Also, the drain hole on the cooler is a few inches above the bottom. Could I just prop the other end of the cooler up during the whole process to put the drain hole more toward "the bottom." I would secure it so it wouldn't slip, of course.
Thanks a bunch!
I don't mean to be impatient, but I'm going to stop by Lowe's on the way home...
Here is my post from the other thread:
I've read about how to make the round MLT with the Rubbermaid drink cooler. I have a rectangle cooler (I'm not sure but I think it's about 10 gallons. I'd say it's "medium" sized from what I've seen with a lot of coolers).
My question is... Can I still do the 12" stainless steel braid or does it have to be bigger?
Also, the drain hole on the cooler is a few inches above the bottom. Could I just prop the other end of the cooler up during the whole process to put the drain hole more toward "the bottom." I would secure it so it wouldn't slip, of course.
Thanks a bunch!