I wanted something I could move around and even let people borrow if needed. I also required an unswitched outlet so I could run a fan/blower or other device if needed.
Here is how I did it...
I attached a parts list but if you don't do electrical stuff you will also need some loose wire and wire caps to wire everything together.
Pretty easy setup with a couple caveats...
1) When you trim the cover plate trim it all from one side. Space is tight and you will only be able to use one clip to secure the Love controller. This means you need all your space to be on one side. A Dremel is the easiest way to trim up the cover and it doesn't really need to be cleaned up as it is all behind the controller once everything is installed.
2) Space is so close you'll need to trim the catch release off the clip before assembling or it will just release and loosen up. I didn't snap a pic of it but what needs to come off is pretty obvious and easy to take care of with a Dremel.
3) Wiring it up is all basic stuff but getting the box closed is a real PITA. There is a lot of wiring and space is tight. This is made worse by the controller being deep so there can't be much packed in behind it. Oh and the controller is attached to the cover plate so the controller has to go in last and you can't jockey the wires very much while it is going in. Really not bad though as long as you fold everything in and pre fold the wiring behind the controller so it falls into place as you push the controller in.
Here is the wiring diagram I made. It has a lousy back of the napkin look to it but it works so here it is.
View attachment LoveBox.pdf
Here is how I did it...
I attached a parts list but if you don't do electrical stuff you will also need some loose wire and wire caps to wire everything together.
Pretty easy setup with a couple caveats...
1) When you trim the cover plate trim it all from one side. Space is tight and you will only be able to use one clip to secure the Love controller. This means you need all your space to be on one side. A Dremel is the easiest way to trim up the cover and it doesn't really need to be cleaned up as it is all behind the controller once everything is installed.
2) Space is so close you'll need to trim the catch release off the clip before assembling or it will just release and loosen up. I didn't snap a pic of it but what needs to come off is pretty obvious and easy to take care of with a Dremel.
3) Wiring it up is all basic stuff but getting the box closed is a real PITA. There is a lot of wiring and space is tight. This is made worse by the controller being deep so there can't be much packed in behind it. Oh and the controller is attached to the cover plate so the controller has to go in last and you can't jockey the wires very much while it is going in. Really not bad though as long as you fold everything in and pre fold the wiring behind the controller so it falls into place as you push the controller in.
Here is the wiring diagram I made. It has a lousy back of the napkin look to it but it works so here it is.
View attachment LoveBox.pdf