I dont really think the GPM is a huge factor - Anywhere above 5 should do just fine (i think) line size is 3/8 and it is a 16 foot run with a 6 ' vertical.
Yes it is a two tower glycol system in my residence so it does not move huge volumes like a bar would.
I purchased the Shurflo 8005-733-155 for my system but it is WAY to loud.
8000 Series Delivery Pumps
it is in my basement and I can hear it in my living room. I wonder if it is a function of not having enough power to lift the coolant up 6 verical feet?
Any one reccomend a pump that...
Hi - I want to buy my son a Lionel train for christmas. I am heading to the shop on Monday to look at them. he is only 7 months old so all i want to buy is the engine and I will buid the set over time.
My question is with so many options is there one that is considered "the" lionel...
I have a 5 gallon recipe I want to make 10 gallons....... I figure I will double the ingredients......Do i need to add 2x the yeast or just add the same amount and wait a little longer?
at $9 a pop I would like to conserve if possible
Not sure if it matters but it is the YEAST STRAIN: 1335...
So does anyone have any advice as far as what type of bucket/ container to use for a freezer Glycol container? I bought a rubbermaid trash can that fits in the freeer perfectly but want to make sure that there are no isssues with the glycol and the rubbermaid having an adverse reaction?
the...
I am almost done with my glycol system. i had to buy the 3/8" id tubing and was wondering how I am going to connect it to the ball lock? Any ideas?
i could do a splicer to a 3/16 line but would rather not.
There is a drastic difference in the vinyl hose that most people use in kegerators and the Polyethylene Tubing that is used in the glycol systems.
I am using the Polyethylene Tubing.
By the way I spoke with a rep from micromatic and he said that (by blind luck on my part) I had the...
they dont sell it - This is the only hose they sell that carries two types of beer:
Beer Line Hose - Trunk Line
I guess i could pull out the 3/8 and put in the 3/16.
Sorry if I am creating too many posts about this but I dont see why this is so hard for me. I started off thinking I was going to do an air cooled system but there were too many funky turns and I was not sure I could get the air circulation I need.
So I bought the following glycol tower...