Thanks! I’m also not going to take a sale that leaves me with a bunch of accessories that are useless to me if I can avoid it (not to mention accessories that demonstrably make the product better).
Fortunately I don’t have to since this has all been sold.
Thanks for the interest.
I have two 3.5 gallon Ss Brewtech Brew Bucket Mini fermenters I'm looking to move along with the blowoff kits and an extra base. I used them for 2.5 - 3 gallon batches, but my new system cannot brew that small of a batch.
Asking $265 shipped.
I suppose it depends on if you want the base. Price for a large flat rate box is $17.90. For a medium (if you didn't want the base), it is $12.65. The base is just a piece of plywood I cut a hole in.
I have a Monster Brewing Hardware MM-2 grain mill I am looking to unload. It's a great mill and I would still be using it, but I switch between traditional brewing and BIAB and needed a mill that I could adjust the gap easier.
It is the 3/8" shaft and 1144 steel. I can include the pictured...
Hmm. But then my probe isn't in direct contact with my wort. I think I found what I'm looking for:
http://forum.embeddedcc.com/viewtopic.php?f=6&p=584
Thanks, though!
Hi all. I have an electric brewery with my temp probes for my BCS-460 running through standard NPT compression fittings (all purchased from Brewers Hardware). No big deal. But, I also have a Megapot that has no ports in it that I use for BIAB. I want to start using a heat stick, but am...
I have a Ranco ETC-111000000 prewired temperature controller for sale. It is about a year and a half old and in perfect working condition. It works wonderfully and had my brewing situation not changed to where I need a dual stage controller, I would still be happily using it.
Details here...
I use the Bayou Classic 1144, which is 44 quarters (or 11 gallons). I just did a 1.075 beer and still had ample room.
EDIT: If you don't want the fryer basket, the Bayou Classic 1044 is the same kettle.