Recent content by SeanP

I found this while asking myself a similar question before cutting into a much cheaper pot and wanted to share for anyone else wondering. My experience has been that it's more difficult than it looks, but then it goes. Don't drill fast, but don't go too slow, and definitely use the right tool...

You're right, I saw a friend's setup with one of those, and it was a PITA to fit inside a fridge.

I have seen the question of internal/external CO2 tanks in a kegerator build addressed many times on here, but what about keeping the tank in the fridge with a line out to the regulator, and the gas line(s) back in to the fridge? Yes, it's one/two more hole(s) to drill compared to keeping both...

Any luck? Doing mine soon.

I am going to start drilling a hole for the tower soon. Who has had success with the Igloo FR465, and where did you drill the hole? Who has run into lines with this model and where were they? Not clear in some of the posts who has what model fridge and where the hole was being drilled. I'm...

Thanks for the response, and good point! I saw your post and immediately went and grabbed some 3M cold weather metal tape from Lowe's, here's hoping that it forms a good seal for me. Thanks to the OP for this thread, super helpful! Working on an Igloo FR465 right now.

I didn't see any screws on the door in my Igloo FR465 so I manhandled the plastic off and sawed off the excess insulation. The only problem I found is I need to re-seal part of the rubber around the door that I almost tore off... I see a lot of different ways that people have re-covered the...

I appreciate the input, everyone! I think I'll stick with the plastic funnel for now. My last batch turned out just fine!

Hello, I apologize if this topic has been posted elsewhere, but I did not see it. I recently purchased a carboy and have been looking around at funnels so that I can pour wort directly from the spigot on my BK to fermentation. I've learned that this is the period in which sanitation becomes...