Recent content by EyeofdaHawk

Yep, will do. Going to get one tomorrow. Just hope i haven't hurt anything.

Hi people Finally have both a finished (or so i thought) control box, and a 32A circuit. Plugged in my control box for the first time and turned the key. Pop... Fuse dead (i think). The Circuit breaker did not go, so i guess that's a positive. I literally have no idea where to go from here...

So i need 3 more switches? I was trying to do a slightly modified version of this

Sorry i clearly wasn't clear. I have a switch wired to the buzzer like in above, just goes straight from the buzzer to the switch with neutral back to neutral bus.

Can someone please check if wire the alarm buzzer and on/off correctly? It's via the Ezboil 120, 310 and SLY. Put the hot bus to 13 on on the Ezboil 120, then this is wired to 13 on the ezboil 310, and to 2 on the SYL. Wired the 1 to the 14 for the Ezboils, and but not for the SYL (doesn't have...

Ah right, i think i've done that. Put the hot bus to 13 on on the Ezboil, then this is wired to 13 on the ezboil, and to 2 on the SYL. Wired the 1 to the 14 for the Ezboils, and but not for the SYL (doesn't have a 13 + 14). Connected 1 on the SYL to the alarm switch, and this to the alarm...

Oh actually for some reason my DSPR120 does not have connecorts 13+14...

Hi again, sorry this is an addtional question. I'm trying to figure out how to wire int he alarm, from 2 Ezboil, (120 and 320) and a SYL. Alarm wiring appears to be both 1+2 and 13+14. I'm not using a timer, and so will go straight to the alarm and alarm off switch. Can i just wire up the DSPRs...

Thanks Mike Have hooked it up like that. Not just have to connected the alarm and it's done. Cheers Hawk

Hi Mike, could you possible show me how to wire the volt bit of the volt/amp meter? I've followed your design for the amp bit, but not sure where to wire the volt meter wires. Can't figure exactly from the above discussion. Pretty much done after that. Thanks Hawk

Woowzer that's cheap. The build i'm doing now would have cost at least that in parts, not to mention build time...

Even if the Hot wire to the SSR doesn't go through the hot bus?

Thanks. Yep i have looked closely at the Auberins setup. Sadly it is very unclear for those doing more than BIAB setups. Clearly that is their main market. I wonder if putting it before and after the main power coil would work as it connects all the components including the pumps and lights, not...

Thought i should also add, build so far:

Sillbeer, would you by chance have the wiring diagram for that? I've got almost the exact same build going. Just different in i have 4 element ins, and a couple extra switches/lights. Still trying to figure out how to wire that amp/volt meter and the PIDS to the alarm.