Recent content by DrewC

I'm in Gloucester County, NJ. This is built using perforated steel. Keggle HLT with thermometer and sight glass. Keggle kettle with sight glass and whirlpool outlet. Coleman extreme MT with CPVC manifold. All high temp tubing with QDs on all outlets and tubing. One pump with QDs and valve...

Thanks again for running yet another group buy.

Paid and thanks again.

2 x CM-2 ROW Thanks

I have one. I am upgrading to a plate chiller. I'm in south jersey. PM me if interested for $20.

Missed that this was shut down.

Just ordered some ingredients in bulk and i am struggling on what to make. *All-Grain, Partial-Mash, or Extract? AG *If All-Grain, what is your estimated efficiency? 70% *Boil time? In minutes. 60 min *Will you rack to secondary? No *Hop Pellets or Leaf? Pellets *What is your...

Put me down for 1 CM-PALE

I'm in south jersey...I dont have a trade but I would purchase.

Well I am finishing up my build on my single tier stand. I want to wire up a gfci to a switch in an outdoor waterproof box, then just plug in my pump and use the switch for on/off. I want to make sure my wiring is correct. My plan is to cut the female end off an extension cord and wire it to the...

I will still have another orifice screwed into each burner. I guess I'm trying to save some cash and reuse the regulator I have.

I'm putting together my parts for my manifold. I was going to use my regulator off my SQ14 burner. My plan was to have that thread into a bushing that connects to the black pipe, then to a tee, to a valve, etc, etc. My regulator hose has the orifice attached. Any problems with this?

BrewerRick- I will be mounting my burners and pump exactly as you have. Did you order additional angle iron or did you have enough left over from the amount specified in the original plans?

Gremlyn, I'm planning on building one of these and I also use a coleman extreme as my MLT. Do you have any support for the extra length of the cooler or do you just center it?

Put me down for 1 BD-MOPA