Recent content by bruker

I finished my keezer last fall and have been very satisfied with how it turned out. I'd like to put a hefeweisen in it next but am unsure how the sediment normally found in a hefe will work out. Will the first pours have a lot of sediment and the last ones more clear?

I have my keezer finished and will be ready to put a couple sixtels in it soon. What settings are good starting points for the Inkbird ITC-1000?

I'm getting close to completing my two tap Coffin keezer with tapbox. Do the copper tubing assemblies really do a good job with keeping the beer lines in the tapbox cool?

From the floor to the bottom of the lid I'm going to have 26" in my non-collar keezer. Will a standard Sanky coupler work or will I need to go with a low-profile connector?

Another newb question... What's the difference between an STC-1000 and an ITC-1000? Advantages, disadvantages?

I'm probably going to end up with something similar to what ZuzBrews did. Does it matter where the freezer's stock thermostat is set at or not?

Here's an old topic www.homebrewtalk.com/forum/threads/guide-to-set-internal-chest-freezer-thermostat-to-32f-eliminate-external-control.249612/ that explains how to use the existing freezer temperature controller to control the temperature vs. using and external (ex. STC-1000). Is anyone here...

First time builder here and I'm looking for some recommendations for a two tap tapbox. -What's a good height to place the shanks? -What's a good distance between the shanks? -Make the top of the box accessible for maintenance? -Is it OK to located the STC-1000 and wiring in the tapbox? -What's...

Looks like two sixtels setting on the floor. That's just what I'm looking to do. Do they fit snug down there or is there room?

How's the build going? Any new picks for us? *Never mind. Found your other thread.

^Thanks for your reply. If you get a chance could you get the dimensions of the lower section and the height? I'd like to build a two sixtel keezer but am trying to get by without a collar.

Can you fit two sixtels diagonally in the lower section?

Looking better. What's the interior dimensions of the low area of the freezer? Please show some pics when you get your kegs inside.

Looks good. What size kegs are you planning to use?

Little confused... In this thread you say you can't fit two 1/6th's on the floor but in your other thread you say you can.