Originally Posted by Khemikal
Has anyone picked one of these things up yet? Have any issues getting all your components stuffed into it?
I was wondering about this box too.http://www.auberins.com/index.php?ma...roducts_id=305
I can only see one problem with factory pre-cut layout - it is impossible to install a 22mm hole switch directly under the right side PID or timer hole because the door latch is on the way.
I am OK with its dimension otherwise.
For the past 10 months I have been using almost the same size ABS plastic enclosure, only a 2" shallower - 12x16x6 (300x400x160) made by Bud Industries NBF-32026 to house my RIMS setup.
The problems is it has just cracked around PID and adjacent switch.
This POS's total cost with inner panel was $70, but easy to cut holes in.
This box easily houses 2 PIDs and 1 same DIN size Auber timer nicely.
I only used 1 contactor inside this box, so with 3 relays it may get tight in there. I did not use volt or amp meters in my panel.