Here are some picks of the wiring I am hoping to implement for a bulb in a can heater. I am using a milo can in lue of a paint can, as I cannot see how it will make much difference.
I am hoping to find a sparky friend to give this a once over before I implement it, but thought I would get feed back from here first.
I plan to mount this on the side of my fridge fermentation chamber close to the top with around 3/4 of an inch clearance around all sides.
I plan to screw the bulb and lid to the side of the fridge so that I can clip the can on or off as I see fit.
Your feedback or suggestions for improvement are more then welcome.
I am hoping to find a sparky friend to give this a once over before I implement it, but thought I would get feed back from here first.
I plan to mount this on the side of my fridge fermentation chamber close to the top with around 3/4 of an inch clearance around all sides.
I plan to screw the bulb and lid to the side of the fridge so that I can clip the can on or off as I see fit.
Your feedback or suggestions for improvement are more then welcome.