Williams Brewing Grain Mill Motorizing Kit

[LiquidFlame]

Would this work with a Barley Crusher MaltMill: https://www.williamsbrewing.com/DOUBLE-ROLLER-GRAIN-MILL-MOTORIZING-KIT-P4176.aspx

 

[kh54s10]

Do you want to motorize your Two Roller Milll? This high torque geared grain mill motor fits the 10mm shaft on our item L07 and B21 Two Roller Mills (and any other 2 or three roller mill with a 10mm drive shaft), and features internal gears to spin your mill at 180rpm. A heavy duty spider coupling absorbs the direct drive shock, and the 1 amp motor has plenty of power to turn.
A safety switch is included for mounting on your mill mount. This includes a button that is harder to turn on than turn off (to turn on, twist the red knob and press down, to turn off, just press the red knob).

Measure your shaft.. The one on your mill.

 

[brick_haus]

Couldn't one simply get the proper coupling for their mill shaft, if it's not 10mm, and replace the one that comes with the unit??

 

[Big_Mike]

Would this work with a Barley Crusher MaltMill: https://www.williamsbrewing.com/DOUBLE-ROLLER-GRAIN-MILL-MOTORIZING-KIT-P4176.aspx

I'm looking at the same setup - Williams mill motor kit and the Barley Crusher...

So did it work out for you?

 

[trapae]

I'm going to be doing the set up with a barley crusher as well. Has anyone done this with success? The website says you can hack saw the coupler. I was thinking of sliding a 10 mm brass tube over the 3/8 crusher shaft.