Where can I find the proper gas post for my pinlock keg?

[Paxton]

I have had my kegerator running for a few months now but when I got the gas disconnects I noticed how 1 had the proper size larger barb fitting and the other 2 were too small for my gas lines so I got a coupler and some food grade tubing to get it to at least work but now the tubing and coupler keep slipping off and I'm afraid of leaks so I'm just hoping to find either some sort of converter to a larger barb or some disconnects that will be the right size for my gas lining. Any ideas ? Thank you so much for pointing me in the right direction in advance.:fro:

 

[Paxton]

Also the tubing is 5/16" ID and 9/16" OD. Sorry if the solution is obvious. I'm terrible at stuff like this.

 

[klyph]

http://www.midwestsupplies.com/barbed-swivel-nut-1-4-flare-5-16-barb.html

 

[Paxton]

http://www.midwestsupplies.com/barbed-swivel-nut-1-4-flare-5-16-barb.html

Thanks for the reply. Will this fit over my barb since it's permanent on there? It appears it would fit over and is what is on the screw on connection but not the barbed one.

 

[klyph]

There are 1/4" FFL (Female Flare) which is the threaded one that you connect a swivel nut to. Then there are the barbed ones which you must use the appropriate size hose for. If you absolutely have to use that larger hose, buy more pin lock connectors with the 1/4" FFL and get the swivel nuts with the 5/16 barb for your hose.