Whats the inside of your look like?

[GreenMonti]

No I have the step bit... why?

Cause you said you were lucky that you haven't welded them in yet. I was thinking if you had drilled them so the coupling would pass through then there is no real difference.

 

[Nerdie]

OH i didn't even know that the drill holes were going to be different... so much to learn... i have 3 kegs and a drill bit and a few 1/2" couplers.... waiting.. but it's cold outside and there's a lot of snow... lol

 

[GreenMonti]

OH i didn't even know that the drill holes were going to be different... so much to learn... i have 3 kegs and a drill bit and a few 1/2" couplers.... waiting.. but it's cold outside and there's a lot of snow... lol

If your gonna weld a coupling to the outside of the keegle or do a weld less fitting then I would drill a 7/8" hole. If your gonna put the coupling half in half out then your gonna need a bigger hole. I say bigger cause coupling come in different sizes. There are ones with a casting look to them and there are ones that are turned on a lathe.