What size copper for manifold

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I use 3/8 and drilled a million holes in one side. That side faces down and it will siphon the tun just about dry. If using bigger pipe means fewer tubes or holes that are up higher, there's no advantage. If 1/2 is what fits for your tun, go for it, but don't think that sparging will go any faster... cause it wont
 
I did 1/2" , the fittings and adapters are much more easily found for 1/2" tubing than 3/8".
 
Back
Top