Weldless Triclover Element?

Browningbuck · Jan 15, 2015

the 20" diameter of the kettle along with the 3/32 or 1/8 silicone gasket made for a great seal (no leaks in 7 hours) im also only using the gasket on the outside. if i wanted it came with a gasket for the inside as well.

beeton · Jan 15, 2015

If you use a gasket on each side,
would the pot be grounded?

Browningbuck · Jan 15, 2015

yes, with a 1 7/8" hole you almost have to thread the unit on to the kettle.

flatulentfox · Apr 13, 2015

Just got two of these installed. Great product. Also, the instructional video on your (bobby's) site was super helpful. Thanks for the great products.

Bobby_M · Apr 14, 2015

Nice job on that solder. That's about as good as I can pull it off myself and I've done about 25 of them now.

Compacto · Jun 14, 2015

I'm really interested in picking up two of these but I'd like to see a picture of the inside of the flange inside the kettle. You mind posting one, Bobby? Also, is the inner face of the flange wide enough that if you cut the hole a bit wider than the ID of the flange, you could solder to it as well?