Temp Controller Probe and Fan wires

[OscarBrau]

I'm building a keezer and am curious what everyone does with the Temperature controller probe and (if they have one) fan wires. Do you feed the wires through a hole in the keezer collar or do you just lay them over the collar and close the lid on them? I was thinking of just closing the lid on them, but wasn't sure how much air leakage would happen.

Thanks!

 

[DC_0602]

I have the same predicament, I plan to just lay them over the collar.

 

[BrooklynTom]

I drilled a hole just large enough for the probe than pushed the fan wires through the same hole. Also,
to prevent air leakage, I packed some insulation in with them.

 

[maierhof]

My advice is to put a small hole into the collar and seal it back up with Hot Glue from a gun of some cheap price... If you seal up the front and the back it will be air tight and you are done...

http://www.amazon.com/s/?ie=UTF8&ke...vptwo=&hvqmt=b&hvdev=c&ref=pd_sl_7t9xu6e1xq_b

 

[Troutchaser]

I also drilled a hole in the collar then filled it in with some caulk.