Stripped Sensor

[J-Pizzel]

Tripped on the wire and pulled it right out of the sensor tonight. Where can I buy a new one of these guys, get it cheap and asap? Thanks guys! 8

View attachment 1417669477975.jpg

 

[stlbeer]

If you can solder you can fix it yourself. Undo the screws for retaining the wire at the back end of the sensor, then unscrew the middle of the connector from the body.

Make sure you push the wire through the body of the connector before soldering the wires back on.

See the video at this link - http://www.auberins.com/index.php?main_page=product_info&cPath=7_43&products_id=118

At the 12 second point in the video you'll see what I mean.

 

[J-Pizzel]

Thanks!

 

[J-Pizzel]

If you can solder you can fix it yourself. Undo the screws for retaining the wire at the back end of the sensor, then unscrew the middle of the connector from the body.

Make sure you push the wire through the body of the connector before soldering the wires back on.

See the video at this link - http://www.auberins.com/index.php?main_page=product_info&cPath=7_43&products_id=118

At the 12 second point in the video you'll see what I mean.

How do I figure out which wire goes to which solenoid? There's 3 for each one....

 

[stlbeer]

How do I figure out which wire goes to which solenoid? There's 3 for each one....

Haha! Great question!! Look closely and you'll see a number for each pin. Either 1, 2, or 3.

Now, you'll need to disassemble the other end as well. Sorry I didn't mention that. There are 2 reds and 1 white wire. The reds don't matter so long as red to red and white to white.