wilconrad
Well-Known Member
Is there any possibility to add a feature to disable the alarm? I'm wiring up a control box and getting it all set up. Right now I don't have phone jacks wired to all of my temp sensors yet and they are a bit loud! Or is there a way to soft power them off while the alarm is running? I've tried plugging a sensor into the jack, soft powering one off, then pulling it out to plug into another to do the same, but the first one powers back on when I remove the sensor. I should have wired in a manual power switch to each one, but alas I did not think of that until they all started screaming at me!
If you're comfortable with a soldering iron, you could remove the speaker/buzzer from the board on each STC. Or you could just finish wiring up the sensors...