I apologize for adding to the number of STC-1000 threads, but I can not find a post that specifically addresses my wiring question. Keep in mind that I'm a total noob at electrical wiring, although I have rigged up my Control Products TC-9102D-LV Dual Stage temp controller for a fermentation chamber, so I'm not a complete idiot (usually).
I am looking for assistance in wiring an STC-1000 for my keezer, therefore I will only be using it for cooling. I would also like to wire in an always-on fan for circulation (I have a very tall collar). I have found some diagrams which have fans wired in, but they are using both stages of the temp controller. I don't know how to modify those layouts for single stage use.
I am almost certain this has been asked before, so just a link to an old post would probably suffice. I just can't seem to find it after searching extensively. Any help would be greatly appreciated.
I am looking for assistance in wiring an STC-1000 for my keezer, therefore I will only be using it for cooling. I would also like to wire in an always-on fan for circulation (I have a very tall collar). I have found some diagrams which have fans wired in, but they are using both stages of the temp controller. I don't know how to modify those layouts for single stage use.
I am almost certain this has been asked before, so just a link to an old post would probably suffice. I just can't seem to find it after searching extensively. Any help would be greatly appreciated.