jc513
Member
Getting ready to build a keezer and I'm wondering if anyone has wired the outlet differently? The diagram I've seen has you wiring 1/2 an outlet for cooling, and the other half for heating. I don't have any need for heating.
This is the wiring article I'm referencing. https://www.homebrewersassociation.org/pimp-my-system/build-temperature-controller/
I know a little bit about electric, but it also makes me a little nervous. So here are my questions:
1. If I skip the heating part of the wiring, and run a 'hot' line directly from the power source to the hot side of the other outlet, that would make that half of the outlet always on. Correct?
2. Or if I don't wire the other half of the outlet at all, and don't break the tab between the outlets, that would make it so both outlets were cold. Correct?
Thanks,
john
This is the wiring article I'm referencing. https://www.homebrewersassociation.org/pimp-my-system/build-temperature-controller/
I know a little bit about electric, but it also makes me a little nervous. So here are my questions:
1. If I skip the heating part of the wiring, and run a 'hot' line directly from the power source to the hot side of the other outlet, that would make that half of the outlet always on. Correct?
2. Or if I don't wire the other half of the outlet at all, and don't break the tab between the outlets, that would make it so both outlets were cold. Correct?
Thanks,
john
