Run4BeerCO
Active Member
I have a 3 keggle system and I'm looking to add a Stainless Brewing Herms coil. Any suggestions on the 25' vs 50' coils? I'm leaning towards the 25' coil because I think I'll be able to utilize a plugged off bulkhead. If I go with 50', I'll more than likely have to drill two new holes.
My other question is what fitting should I be using? I can't really tell the advantages between the two fittings recommended by stainless brewing... Is there a reason I would want to go with the longer threads with the washer? Is their a downside to going no washer and shorter threads?
http://www.stainlessbrewing.com/Com...-Connector-with-Gasket-and-Washer-_p_109.html
http://www.stainlessbrewing.com/12-Compression-x-12-Male-NPT-weldless-Bulkhead-fitting-_p_188.html
Thanks for the help!!
My other question is what fitting should I be using? I can't really tell the advantages between the two fittings recommended by stainless brewing... Is there a reason I would want to go with the longer threads with the washer? Is their a downside to going no washer and shorter threads?
http://www.stainlessbrewing.com/Com...-Connector-with-Gasket-and-Washer-_p_109.html
http://www.stainlessbrewing.com/12-Compression-x-12-Male-NPT-weldless-Bulkhead-fitting-_p_188.html
Thanks for the help!!