SS Brewtech Infusion Mash Tun - Recirculation Bulkhead Fittings?

[IPAddiction]

Just received the Infusion Mash Tun for Christmas and, as has been my experience with all of my SS Brewtech equipment... the instructions are far from sufficient. Managed to figure most everything out, but am stumped by the tri clamp fitting on the Recirc. Bulkhead - it looks to be a 3/4" but in my search for 3/4" tri clamp w/ a standard male quick disconnect fitting, I'm coming up with nothing. Even ran this by my local homebrew shop (which works with professional breweries and homebrewers alike) and they were as confused as I was.

Has anyone out there managed to figure this out?

Thanks!

 

[passedpawn]

Like this?

 

[Bobby_M]

Jeez, I've spent some 10 years making single fittings to go from this to that and I thought I covered everything. I could weld a male QD to a 3/4" TC blank, probably.

 

[passedpawn]

Jeez, I've spent some 10 years making single fittings to go from this to that and I thought I covered everything. I could weld a male QD to a 3/4" TC blank, probably.

That nasty dirty quick disconnect above is yours. (it was clean when I received it lol).

https://www.brewhardware.com/product_p/blqdmalecompression12.htm

 

[Bobby_M]

That nasty dirty quick disconnect above is yours. (it was clean when I received it lol).

https://www.brewhardware.com/product_p/blqdmalecompression12.htm

Oh I recognized it but you understand why I didn't jump to take credit ;-)

 

[passedpawn]

Oh I recognized it but you understand why I didn't jump to take credit ;-)

I swear it was "clean" when I put it away. There was a cover over it that I removed to take the picture in the dark... n/m, ok, it's a mess

 

[IPAddiction]

Thanks all. Took a look at Passed Pawn's pic and went searching for 3/4" TC w/ a 1/2" MPT and found it on Brewers' Hardware. Problem solved!