tyler180
Member
Doesn't Blichmann have a similar mill. If so, how does the Blichmann compare?
I realize probably all these mills are made in Chinese prison factories...
I just got the Blichmann grain mill. My rollers are even further off. They're about 22% different between sides. I contacted their support and apparently the engineers seem to think it's totally fine. I tried to run some grain through it and the mill jammed up. Here's a video I took of it jamming up. This is the original video I sent them, and they said this was totally fine. I've been incredibly disappointed with the entire process. After spending this much money on a mill I expected it to be more precise than the Barley crusher I had before it. I can understand mistakes with a mill getting past QA, but then to have support tell me it was fine is incredible disappointing. When their supplied gap gauge was showing the gap to be WAY off I thought it was going to be an easy exchange. Instead they told me to run some grain through it first and waste more time waiting to get a properly working mill. Of course just running some grain through it sounds like a super quick and simple task, but this thing is a beast and I can't just set it on a bucket and test it. There's assembly and setup before even being able to put grain through it.