So I figured, why not, kill a few birds with one stone? I have had this in the back of my mind for a long time so it was somewhat planned out so I put it into action. I have repaired computers for a couple decades for a living so I was on solid ground & here is the final product.
A computer with Windows 10 with full Wi-Fi so I can bring up HBT & all my recipes while brewing. I can bring up OneNote and edit anything I need for later reference as all my brewing notes from the last several years are on it.
As you can see, my STC1000 temperature controller is mounted in an expansion bay at the top (no cutting was needed) can you believe that?
The sensor goes right down in to the fridge the computer is sitting on.
Inside the fridge are 3-12 volt fans, so I hooked them up with a Molex connector then connected them inside of the computer.
So, I am set up for whatever I need do.
A computer with Windows 10 with full Wi-Fi so I can bring up HBT & all my recipes while brewing. I can bring up OneNote and edit anything I need for later reference as all my brewing notes from the last several years are on it.
As you can see, my STC1000 temperature controller is mounted in an expansion bay at the top (no cutting was needed) can you believe that?
The sensor goes right down in to the fridge the computer is sitting on.
Inside the fridge are 3-12 volt fans, so I hooked them up with a Molex connector then connected them inside of the computer.
So, I am set up for whatever I need do.
