Here's the new stand. Went with 1.5" x 16 gauge tube. I had a friend weld it as I want not interested in tackling such a project, especially it being stainless.
The three burners (SQ-14s) are all mounted to a single bar which can raise and lower via the threaded rod and wingnuts.
Must have the mandatory water filter mounted on as well.
Here are the burners. The heat shields are made from an old corney I had laying around. The shields are spot welded to the frame.
Here's some shots of the shine and welds. Not perfect but purdy enough for me.
The gas manifold is built into the frame to avoid an unsightly external black iron pipe manifold.
This goes to the 100 gallon propane tank.
I also created some heat shields for the thermos and spigots to prevent burning from flames. Kudos to BobbyM for the design.
A shot of the new mash paddle...
All the whole stand fits underneath my work bench too.
The three burners (SQ-14s) are all mounted to a single bar which can raise and lower via the threaded rod and wingnuts.
Must have the mandatory water filter mounted on as well.
Here are the burners. The heat shields are made from an old corney I had laying around. The shields are spot welded to the frame.
Here's some shots of the shine and welds. Not perfect but purdy enough for me.
The gas manifold is built into the frame to avoid an unsightly external black iron pipe manifold.
This goes to the 100 gallon propane tank.
I also created some heat shields for the thermos and spigots to prevent burning from flames. Kudos to BobbyM for the design.
A shot of the new mash paddle...
All the whole stand fits underneath my work bench too.