sight glass marking

[bdaddy]

What do you guys use to mark off your sight glass measurements? I have the bargain fittings sight glass and looking for something a little nicer than just magic marker, if possible. Something like this would be ideal, but I have no idea what was used here:

http://picasaweb.google.com/1099743...hkey=Gv1sRgCMqqhYynqZPNcg#5504962944340479922

 

[android]

bobby_m seems to have those stickers on his website, but I don't know if they're sold independent of a sightglass kit. brewhardware.com

 

[bob1852]

go to Bobby_M's website and you can order some cool markings - they're really cheap.

http://www.brewhardware.com/index.p...ration-numbers&catid=38:accessories&Itemid=62

 

[JetSmooth]

I just use Sharpie marker, but I also mark out my target volumes with o-rings I slide up and down the tube (pre boil target, post-boil target, etc)

 

[bdaddy]

perfect..thx! And nice idea with the o-rings for targets as well.

 

[bad coffee]

you could etch the plastic. Look for the marking a carboy thread. I forget the name. Blame SNPA.

B

 

[IDrinkBr]

+1 for Bobby_M vinyl numbers. Easy to read/install

 

[Jud]

Sharpie it is cheap.

 

[Bobby_M]

Interesting that the picture in the OP is actually the numbers I sell on my site. That keg was the one I setup in the video on my instructions page.

Sharpie is cheap, but it's not very easy to make look good. I mean, come on, it's 2 bucks a strip for the vinyl numbers.